Paradyne COMSPHERE 3910 Installation And Operation Manual page 53

3900 series point-to-point/multipoint modems
Hide thumbs Also See for COMSPHERE 3910:
Table of Contents

Advertisement

VF
VF displays the condition of the leased or dial connection.
To access VF from the Status branch, make the following selection:
Select VF.
If the modem is receiving a signal, the signal quality appears on the LCD's bottom line. Press the
end echo level, far end echo delay, and echo frequency offset. If the modem is not receiving a
signal, the message No Signal appears on the LCD.
SigQual
RcvLevel
Sig/Noise
NrEchLvl
FarEchLvl
FarEchDel
EchoFreqOff
3910-A2-GN32-30
Status:
DeviceHS
F1
F2
Status:VF
SigQual=Excelent
F1
F2
key to scroll and view the receive signal level, signal-to-noise ratio, near end echo level, far
Signal Quality displays the condition of the VF line. Possible values are
Excelent (Excellent), Good, Fair, Poor, or No Signal. These values appear
for V.32 terbo, V.32bis, and V.32 modulations.
Receive Signal Level displays, in decibels referenced to one milliwatt
(dBm), the actual strength of the incoming signal. This value appears for
V.32 terbo, V.32bis, V.32, and Trellis Multipoint modulations.
Signal-to-Noise Ratio displays, in decibels, the receive signal strength
relative to noise on the line. This value appears for V.32 terbo, V.32bis, V.32,
and Trellis Multipoint modulations.
Near End Echo Level displays the signal level, in decibels referenced to one
milliwatt (dBm), of that portion of the transmit signal which has been
echoed back by the local line termination. This value appears for
V.32 terbo, V.32bis, and V.32 modulations.
Far End Echo Level displays the signal level, in decibels referenced to one
milliwatt (dBm), of that portion of the transmit signal which has been
echoed back by the remote line termination. This value appears for
V.32 terbo, V.32bis, and V.32 modulations.
Far End Echo Delay displays the roundtrip delay in milliseconds of the far
end echo. This value appears for V.32 terbo, V.32bis, and
V.32 modulations.
Echo Frequency Offset displays the frequency offset of the far end echo.
This value appears for V.32 terbo, V.32bis, and V.32 modulations.
November 1996
>
VF
F3
>
F3
DCP Operation
3-19

Advertisement

Table of Contents
loading

This manual is also suitable for:

Comsphere 3911

Table of Contents