Connection Through A Serial Interface - Siemens sinamics dcp Operating Instructions Manual

Results of the preceding steps
● You have generated a project for your drive unit using the STARTER offline
● You have saved your project data to your PC hard drive
● You have transferred your project data to the drive unit
● You have saved your project data in your drive unit's FLASH memory so that it is backed
up in the event of a power failure
7.3.2.6

Connection through a serial interface

Along with the connection through the PROFIBUS, there is also a facility for data exchange
via the serial interface.
Requirements
● A serial interface (COM) must be available on the PC from which the connection will be
made.
Connecting cables
Image 7-22
SINAMICS DCP
Operating Instructions, 05/2016, A5E34382853K
7.3 Commissioning with the STARTER commissioning tool
Assignment, RS232 cable
Commissioning
99