Safety Notes; Servicing - Siemens sinamics dcp Operating Instructions Manual

Safety notes

Note
In the interests of clarity, these Operating Instructions do not contain full details of all
information for all product types and cannot take into account every possible aspect of
installation, operation, or maintenance.
Should further information be desired or should particular problems arise which are not
covered sufficiently in the Operating Instructions for the purchaser's purposes, please
contact your local SIEMENS office.
We also draw your attention to the fact that the contents of these Operating Instructions are
not part of and do not modify any prior or existing agreement, commitment, or legal
relationship. The Purchase Agreement contains the complete and exclusive obligations of
Siemens, including the warranty provisions. Any statements contained in these Operating
Instructions neither expand nor restrict the scope of these contractual warranty conditions.
Note the safety instructions
Operating, servicing, maintaining or installing the SINAMICS DCP may result in property
damage, serious injury, and even death if the safety instructions are not observed.
You must strictly comply with all notes regarding intended use. Different operating modes,
overloads, load cycles, and differing ambient conditions are permitted only after special
arrangement with the manufacturer.
Qualified personnel
The system is at a hazardous voltage. Failure to comply with these Operating Instructions
can lead to death, serious injury and material damage.
Only qualified personnel are permitted to work on this system. Such personnel must be
thoroughly acquainted with all the warnings and maintenance procedures referred to in
these Operating Instructions.
Perfect, safe and reliable operation of the system assumes that it has been professionally
transported, stored, mounted and installed as well as correct operation and servicing.
Note
In addition to the safety instructions stated here, make sure that the safety instructions in the
manuals for the individual devices are also observed and followed at all times when working
with different components.
SINAMICS DCP
Operating Instructions, 05/2016, A5E34382853K
WARNING
WARNING
2
15