Starting The Drive Project - Siemens sinamics dcp Operating Instructions Manual

7.3.2.5

Starting the drive project

You have generated a project and saved it to your hard disk. The next step is to transfer your
project configuration data to the drive unit.
Transferring a STARTER project to the drive unit
The following steps are required to transfer the STARTER project created offline to the drive
unit:
● Step 1
Select the menu command Project > Connect to target system
Selection in the toolbar:
● Step 2
SINAMICS DCP
Operating Instructions, 05/2016, A5E34382853K
7.3 Commissioning with the STARTER commissioning tool
Commissioning
95