Configuring A Bgp Auto-Discovery Ldp Pw - HP 6127xlg Configuration Manual

Step
5. Configure route targets for the
auto-discovery VSI.
6. (Optional.) Reference a PW
class.
7. (Optional.) Reference a tunnel
policy.
8. Use BGP to create a PW to an
automatically discovered
remote PE and enter
auto-discovery VSI BGP
signaling view.
9. Create a local site and enter
site view.

Configuring a BGP auto-discovery LDP PW

Before you perform this configuration, enable MPLS LDP on interfaces and globally. For details, see
"Configuring
To configure a BGP auto-discovery LDP PW, perform the following configurations on PEs:
Configure BGP to advertise VPLS PE information.
•
• Use LDP to create a PW.
Configuring BGP to advertise VPLS PE information
Step
1. Enter system view.
2. Enable BGP and enter BGP
view.
3. Configure the remote PE as a
BGP peer.
4. Create the BGP L2VPN
address family and enter BGP
L2VPN address family view.
5. Enable BGP to exchange
VPLS PE information with the
specified peer or peer group.
6. Enable BGP to exchange
label block information with
the specified peer or peer
group.
Command
vpn-target vpn-target&<1-8> [ both
| export-extcommunity |
import-extcommunity ]
pw-class class-name
tunnel-policy tunnel-policy-name
signaling-protocol bgp
site site-id [ range range-value ]
[ default-offset default-offset ]
LDP."
Command
system-view
bgp as-number
peer { group-name | ip-address
[ mask-length ] } as-number as-number
address-family l2vpn
peer { group-name | ip-address
[ mask-length ] } enable
peer { group-name | ip-address
[ mask-length ] } auto-discovery
[ non-standard ]
382
Remarks
By default, no route targets are
configured for the auto-discovery
VSI.
By default, no PW class is
referenced.
By default, no tunnel policy is
referenced.
By default, no signaling protocol is
specified.
By default, no local site is created.
Remarks
N/A
By default, BGP is not enabled.
By default, no BGP peer is
configured.
By default, the BGP L2VPN
address family is not created.
By default, BGP cannot
exchange VPLS PE information
with a peer or peer group.
By default, BGP can exchange
VPLS PE information with a BGP
L2VPN peer or peer group by
using RFC 6074
MP_REACH_NLRI.