HP 6127xlg Configuration Manual page 296

Step
4. Configure filtering of
advertised routes.
Configure filtering of received
5.
routes.
6. Advertise the COMMUNITY
attribute to a peer or peer
group.
7. Configure ACL-based route
filtering for the specified peer
or peer group.
8. Configure IPv6 prefix
list-based route filtering for the
specified peer or peer group.
9. Specify a preferred value for
routes received from the peer
or peer group.
10. Configure BGP updates sent
to the peer to carry only
public AS numbers.
11. Apply a routing policy to
routes advertised to or
received from the peer or peer
group.
12. Enable route target filtering
for received BGP VPNv6
routes.
13. Configure the local PE as the
route reflector and specify the
peer as the client.
14. Specify the maximum number
of routes BGP can receive
from a peer or peer group.
15. Enable route reflection
between clients.
16. Configure a cluster ID for the
route reflector.
Command
filter-policy { acl6-number |
prefix-list ipv6-prefix-name }
export [ protocol process-id ]
filter-policy { acl6-number |
prefix-list ipv6-prefix-name }
import
peer { group-name | ipv6-address
[ prefix-length ] }
advertise-community
peer { group-name | ip-address
[ mask-length ] } filter-policy
acl6-number { export | import }
peer { group-name | ip-address
[ mask-length ] } prefix-list
ipv6-prefix-name { export |
import }
peer { group-name | ip-address
[ mask-length ] } preferred-value
value
peer { group-name | ip-address
[ mask-length ] } public-as-only
peer { group-name | ip-address
[ mask-length ] } route-policy
route-policy-name { export |
import }
policy vpn-target
peer { group-name | ip-address
[ mask-length ] } reflect-client
peer { group-name | ip-address
[ mask-length ] } route-limit
prefix-number [ { alert-only |
discard | reconnect
reconnect-time } |
percentage-value ] *
reflect between-clients
reflector cluster-id { cluster-id |
ip-address }
287
Remarks
By default, BGP does not filter
advertised routes.
By default, BGP does not filter
received routes.
By default, BGP does not advertise
the COMMUNITY attribute to any
peers or peer groups.
By default, no ACL-based route
filtering is configured.
By default, no IPv6 prefix list-based
route filtering is configured.
The default preferred value is 0.
By default, a BGP update carries
both public and private AS
numbers.
By default, no routing policy is
applied for a peer.
By default, route target filtering is
enabled.
By default, no route reflector or
client is configured.
By default, the number of routes
that BGP can receive from a peer
or peer group is not limited.
By default, route reflection
between clients is enabled.
By default, an RR uses its own
router ID as the cluster ID.
If more than one RR exists in a
cluster, use this command to
configure the same cluster ID for all
RRs in the cluster to avoid routing
loops.