Configuring Hovpn - HP 6127xlg Configuration Manual

224.0.0.0/4
224.0.0.0/24
255.255.255.255/32
5. Verify that CE 3 and CE 4 can ping each other. (Details not shown.)
6. Verify that CE5 and CE 6 can ping each other. (Details not shown.)
7. Verify that CE 3 and CE 6 cannot ping each other. (Details not shown.)

Configuring HoVPN

Network requirements
There are two levels of networks, the backbone and the MPLS VPN networks, as shown in
SPEs act as PEs to allow MPLS VPNs to access the backbone.
•
• UPEs act as PEs of the MPLS VPNs to allow end users to access the VPNs.
Performance requirements for the UPEs are lower than those for the SPEs.
•
SPEs advertise routes permitted by the routing policies to UPEs, permitting CE 1 and CE 3 in VPN
•
1 to communicate with each other, and forbidding CE 2 and CE 4 in VPN 2 from communicating
with each other.
Figure 69 Network diagram
Table 19 Interface and IP address assignment
Device
CE 1
CE 2
UPE 1
SPE 1
Direct 0
Direct 0
Direct 0
Interface IP address
Vlan-int12 10.2.1.1/24
Vlan-int13 10.4.1.1/24
Loop0 1.1.1.9/32
Vlan-int11 172.1.1.1/24
Vlan-int12 10.2.1.2/24
Vlan-int13 10.4.1.2/24
Loop0 2.2.2.9/32
0 0.0.0.0
0 0.0.0.0
0 127.0.0.1
Device
CE 3
CE 4
UPE 2
SPE 2
252
NULL0
NULL0
InLoop0
Interface IP address
Vlan-int12 10.1.1.1/24
Vlan-int13 10.3.1.1/24
Loop0 4.4.4.9/32
Vlan-int11 172.2.1.1/24
Vlan-int12 10.1.1.2/24
Vlan-int13 10.3.1.2/24
Loop0 3.3.3.9/32
Figure 69.