HP 6127xlg Configuration Manual page 278

For more information about configuring basic MPLS L3VPN, see
L3VPN."
2. Configure MPLS L3VPN FRR on PE 1:
# Configure BFD to test the connectivity of the LSP to 2.2.2.2/32.
<PE1> system-view
[PE1] mpls bfd enable
[PE1] mpls bfd 2.2.2.2 32
# Create routing policy frr, and specify the backup next hop as 3.3.3.3 for the route to
4.4.4.4/32.
[PE1] ip prefix-list abc index 10 permit 4.4.4.4 32
[PE1] route-policy frr permit node 10
[PE1-route-policy] if-match ip address prefix-list abc
[PE1-route-policy] apply fast-reroute backup-nexthop 3.3.3.3
[PE1-route-policy] quit
# Configure FRR for VPN instance vpn1 to reference routing policy frr.
[PE1] bgp 100
[PE1-bgp] ip vpn-instance vpn1
[PE1-bgp-vpn1] address-family ipv4 unicast
[PE1-bgp-ipv4-vpn1] fast-reroute route-policy frr
[PE1-bgp-ipv4-vpn1] quit
[PE1-bgp-vpn1] quit
# Specify the preferred value as 100 for BGP VPNv4 routes received from PE 2. This value is
greater than the preferred value (0) for routes from PE 3, so PE 1 prefers the routes from PE 2.
[PE1-bgp] address-family vpnv4
[PE1-bgp-vpnv4] peer 2.2.2.2 preferred-value 100
[PE1-bgp-vpnv4] quit
[PE1-bgp] quit
3. Enable MPLS BFD on PE 2.
<PE2> system-view
[PE2] mpls bfd enable
Verifying the configuration
# Display detailed information about the route to 4.4.4.4/32 on PE 1. The output shows the backup next
hop for the route.
[PE1] display ip routing-table vpn-instance vpn1 4.4.4.4 32 verbose
Summary Count : 1
Destination: 4.4.4.4/32
Protocol: BGP
SubProtID: 0x1
Cost: 0
IpPre: N/A
Tag: 0
OrigTblID: 0x0
TableID: 0x102
NibID: 0x15000002
Process ID: 0
Age: 00h00m03s
Preference: 255
QosLocalID: N/A
State: Active Adv
OrigVrf: default-vrf
OrigAs: 300
LastAs: 300
269
"Configuring basic MPLS