Configuring Routing Between An Mce And A Pe - HP 6127xlg Configuration Manual

Step
3. Configure the MCE as an
IBGP peer.
4. Enter BGP-VPN IPv6 unicast
address family view.
5. Enable BGP to exchange
IPv6 unicast routes with the
peer.
6. Redistribute the IGP routes
of the VPN into BGP.

Configuring routing between an MCE and a PE

MCE-PE routing configuration includes these tasks:
Binding the MCE-PE interfaces to IPv6 VPN instances.
•
Performing routing configurations.
•
• Redistributing IPv6 VPN routes into the routing protocol running between the MCE and the PE.
Perform the following configuration tasks on the MCE. Configure the PE in the same way that a PE in a
basic MPLS L3VPN is configured. For more information about configuring the PE, see
L3VPN."
Configuring IPv6 static routing between an MCE and a PE
Step
1. Enter system view.
2. Configure an IPv6 static
route for an IPv6 VPN
instance.
3. (Optional.) Configure
the default preference
for IPv6 static routes.
Configuring RIPng between an MCE and a PE
Step
1. Enter system view.
Command
peer { group-name |
ipv6-address [ prefix-length ] }
as-number as-number
address-family ipv6 [ unicast ]
peer { group-name |
ipv6-address [ prefix-length ] }
enable
import-route protocol
[ process-id [ med med-value |
route-policy route-policy-name ]
* ]
Command
system-view
ipv6 route-static vpn-instance s-vpn-instance-name
ipv6-address prefix-length { interface-type
interface-number [ next-hop-address ] |
nexthop-address [ public ] | vpn-instance
d-vpn-instance-name nexthop-address }
[ permanent ] [ preference preference-value ] [ tag
tag-value ] [ description description-text ]
ipv6 route-static default-preference
default-preference-value
Command
system-view
466
Remarks
N/A
N/A
By default, BGP does not
exchange IPv6 unicast routes
with any peer.
By default, no routes are
redistributed into BGP.
A VPN site must advertise VPN
network addresses to the
connected MCE.
"Configuring MPLS
Remarks
N/A
By default, no IPv6 static
route is configured.
The default value is 60.
Remarks
N/A