Configuring A Remote Ccc Connection - HP 6127xlg Configuration Manual

[CE2-FortyGigE1/1/1] quit
Verifying the configuration
# Display L2VPN PW information on PE 1. The output shows that a PW has been established.
<PE1> display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1, 1 up, 0 blocked, 0 down, 0 defect
Xconnect-group Name: vpnb
Peer
192.3.3.3
# Display L2VPN PW information on PE 2. The output shows that a PW has been established.
<PE2> display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1, 1 up, 0 blocked, 0 down, 0 defect
Xconnect-group Name: vpnb
Peer
192.2.2.2
# Verify that CE 1 and CE 2 can ping each other. (Details not shown.)

Configuring a remote CCC connection

Network requirements
Create a remote CCC connection between PE 1 and PE 2 so VLAN 10 on CE 1 can communicate with
VLAN 10 on CE 2.
Figure 90 Network diagram
Table 32 Interface and IP address assignment
Device
PE 1
PE 2
PW ID/Rmt Site
2
PW ID/Rmt Site
1
Interface IP address
Loop0 192.2.2.2/32
Vlan-int20 10.1.1.1/24
Loop0 192.3.3.3/32
In/Out Label Proto
65636/65625 BGP
In/Out Label Proto
65625/65636 BGP
Device
P
351
Flag Link ID State
M 1 Up
Flag Link ID State
M 1 Up
Interface IP address
Loop0 192.4.4.4/32
Vlan-int20 10.1.1.2/24
Vlan-int30 10.2.2.2/24