Configuring Ipv6 Mpls L3Vpn Inter-As Option C - HP 6127xlg Configuration Manual

Configuring IPv6 MPLS L3VPN inter-AS option C

Network requirements
Site 1 and Site 2 belong to the same VPN. Site 1 accesses the network through PE 1 in AS 100. Site 2
accesses the network through PE 2 in AS 600. PEs in the same AS run IS-IS.
PE 1 and ASBR-PE 1 exchange labeled IPv4 routes by IBGP. PE 2 and ASBR-PE 2 exchange labeled IPv4
routes by IBGP. PE 1 and PE 2 use MP-EBGP to exchange VPNv6 routes.
ASBR-PE 1 and ASBR-PE 2 use their respective routing policies and label the routes received from each
other.
ASBR-PE 1 and ASBR-PE 2 use EBGP to exchange labeled IPv4 routes.
Figure 79 Network diagram
MPLS backbone
AS 100
PE 1
Vlan-int12
Vlan-int12
Site 1
Table 27 Interface and IP address assignment
Device
PE 1
ASBR-PE 1
CE 1
Configuration procedure
1. Configure CE 1:
# Configure an IPv6 address for VLAN-interface 12.
<CE1> system-view
[CE1] interface vlan-interface 12
Loop0
Vlan-int12
Vlan-int11
ASBR-PE 1
Loop0
Vlan-int11
Site 1
CE 1
Interface IP address
Loop0 2.2.2.9/32
Vlan-int11 1.1.1.2/8
Vlan-int12 2001::1/64
Loop0 3.3.3.9/32
Vlan-int11 1.1.1.1/8
Vlan-int12 11.0.0.2/8
Vlan-int12 2001::2/64
Loop0
Vlan-int12
Vlan-int11
ASBR-PE 2
Vlan-int11
Site 2
MP-EBGP
Device
PE 2
ASBR-PE 2
CE 2
304
MPLS backbone
AS 600
Loop0
PE 2
Vlan-int12
Vlan-int12
Site 2
CE 2
Interface
Loop0
Vlan-int11
Vlan-int12
Loop0
Vlan-int11
Vlan-int12
Vlan-int12
IP address
5.5.5.9/32
9.1.1.2/8
2002::1/64
4.4.4.9/32
9.1.1.1/8
11.0.0.1/8
2002::2/64