Configuring A Bgp Auto-Discovery Ldp Pw - HP FlexNetwork 10500 Series Configuration Manual

For more information about the peer as-number, peer enable, peer allow-as-loop, peer
reflect-client, reflect between-clients, reflector cluster-id, refresh bgp l2vpn, and reset bgp
l2vpn commands, see Layer 3—IP Routing Command Reference.
Creating a BGP PW
Step
1. Enter system view.
2. Enter VSI view.
3. Configure the VSI to
automatically discover
neighbors through BGP and
enter auto-discovery VSI
view.
4. Configure an RD for the
auto-discovery VSI.
5. Configure route targets for
the auto-discovery VSI.
6. (Optional.) Specify a PW
class for the auto-discovery
VSI.
7. (Optional.) Specify a tunnel
policy for the auto-discovery
VSI.
8. Use BGP to create a PW to
an automatically discovered
remote PE and enter
auto-discovery VSI BGP
signaling view.
9. Create a local site.

Configuring a BGP auto-discovery LDP PW

Before you perform this configuration, enable MPLS LDP on interfaces and globally. For more
information, see
To configure a BGP auto-discovery LDP PW, perform the following configurations on PEs:
•
Configure BGP to advertise VPLS PE information.
•
Use LDP to create a PW.
Configuring BGP to advertise VPLS PE information
Step
1. Enter system view.
2. Enable BGP instance and
enter BGP instance view.
3. Configure the remote PE as
a BGP peer.
Command
system-view
vsi vsi-name
auto-discovery bgp
route-distinguisher
route-distinguisher
vpn-target vpn-target&<1-8>
[ both | export-extcommunity |
import-extcommunity ]
pw-class class-name
tunnel-policy tunnel-policy-name
signaling-protocol bgp
site site-id [ range range-value ]
[ default-offset default-offset ]
"Configuring LDP."
Command
system-view
bgp as-number [ instance
instance-name ]
[ multi-session-thread ]
peer { group-name | ip-address
[ mask-length ] } as-number
as-number
381
Remarks
N/A
N/A
By default, a VSI does not
automatically discover neighbors
through BGP.
By default, no RD is configured for
the auto-discovery VSI.
By default, no route targets are
configured for the auto-discovery
VSI.
By default, no PW class is
specified.
By default, no tunnel policy is
specified.
By default, no signaling protocol is
specified.
By default, no local sites exist.
Remarks
N/A
By default, BGP is disabled.
By default, no BGP peers exist.