Configuring Hovpn - HP 6127xlg Configuration Manual

Step
9. (Optional.) Enable BGP
VPNv4 route exchange with
the peer CE or the peer group
of the peer CE.

Configuring HoVPN

In a HoVPN networking scenario, perform basic MPLS L3VPN settings on UPE and SPE. In addition,
configure the following settings on the SPE:
Specify the BGP peer or peer group as a UPE.
•
Advertise the default route of the specified VPN instance or routes matching a routing policy to the
•
UPE.
Create a BGP-VPN instance so the learned VPNv4 routes can be added into the BGP routing table
•
of the corresponding VPN instance by RTs.
Associating an interface with a VPN instance is not required on the SPE because no interface on
the SPE is directly connected to the customer network.
HP recommends not configuring the peer default-route-advertise vpn-instance and peer upe
route-policy commands at the same time.
To configure SPE for HoVPN:
Step
1. Enter system view.
2. Enter BGP view.
3. Specify a BGP peer or peer
group.
4. Enter BGP-VPN VPNv4
address family view.
5. Enable BGP VPNv4 route
exchange with the peer or
peer group.
6. Specify the BGP peer or peer
group as a UPE.
Command
peer { group-name | peer-address
[ mask-length ] } enable
Command
system-view
bgp as-number
peer { group-name | peer-address
[ mask-length ] } as-number
as-number
address-family vpnv4
peer { group-name | ip-address
[ mask-length ] } enable
peer { group-name | ip-address
[ mask-length ] } upe
198
Remarks
By default, BGP does not exchange
VPNv4 routes with any peer.
Remarks
N/A
N/A
By default, no BGP peer is
specified.
N/A
By default, BGP does not exchange
VPNv4 routes with any peer.
By default, no peer is a UPE.