HP 6127xlg Configuration Manual page 138

# Configure MPLS TE to use RSVP-TE to establish the tunnel.
[SwitchA-Tunnel1] mpls te signaling rsvp-te
# Assign 4000 kbps bandwidth to CT 2 for the tunnel.
[SwitchA-Tunnel1] mpls te bandwidth ct2 4000
# Set the tunnel setup priority and holding priority both to 0.
[SwitchA-Tunnel1] mpls te priority 0
[SwitchA-Tunnel1] quit
7. Configure a static route on Switch A to direct the traffic destined for subnet 30.1.1.0/24 to MPLS
TE tunnel 1.
[SwitchA] ip route-static 30.1.1.2 24 tunnel 1 preference 1
Verifying the configuration
# Execute the display interface tunnel command on Switch A. The output shows that the tunnel interface
is up.
[SwitchA] display interface tunnel
Tunnel1 current state: UP
Line protocol current state: UP
Description: Tunnel1 Interface
The Maximum Transmit Unit is 64000
Internet Address is 7.1.1.1/24 Primary
Tunnel source unknown, destination 4.4.4.9
Tunnel bandwidth 64 (kbps)
Tunnel TTL 255
Tunnel protocol/transport CR_LSP
Last clearing of counters: Never
Last 300 seconds input rate:
Last 300 seconds output rate:
0 packets input,
# Execute the display mpls te tunnel-interface command on Switch A to display detailed information
about the MPLS TE tunnel.
[SwitchA] display mpls te tunnel-interface
Tunnel Name
Tunnel State
Tunnel Attributes
LSP ID
Admin State
Ingress LSR ID
Signaling
Resv Style
Tunnel mode
Reverse-LSP name
Reverse-LSP LSR ID
Class Type
Reserved Bandwidth
Setup Priority
Affinity Attr/Mask
Explicit Path
0 bytes/sec, 0 bits/sec, 0 packets/sec
0 bytes/sec, 0 bits/sec, 0 packets/sec
0 bytes 0 drop 0 packets output,
: Tunnel 1
: Up (Main CRLSP up, Shared-resource CRLSP down)
:
: 36882
: Normal
: 1.1.1.9
: RSVP-TE
: SE
: -
: -
: -
: CT2
: 4000 kbps
: 0
: 0/0
: -
129
0 bytes 0 drop
Tunnel ID
Egress LSR ID
Static CRLSP Name
Reverse-LSP Tunnel ID: -
Tunnel Bandwidth
Holding Priority
: 1
: 4.4.4.9
: -
: 4000 kbps
: 0