HP 6127xlg Configuration Manual page 292

Step
12. Enable OSPFv3 on the
interface.
Configuring IPv6 IS-IS between a PE and a CE
An IPv6 IS-IS process belongs to the public network or a single VPN instance. If you create an IPv6 IS-IS
process without binding it to a VPN instance, the process belongs to the public network.
For more information about IPv6 IS-IS, see Layer 3—IP Routing Configuration Guide.
To configure IPv6 IS-IS between a PE and a CE:
Step
1. Enter system view.
2. Create an IPv6 IS-IS process
for a VPN instance and enter
IS-IS view.
3. Configure a network entity
title for the IS-IS process.
4. Enable IPv6 for the IS-IS
process.
5. Return to system view.
6. Enter interface view.
7. Enable IPv6 for the IS-IS
process on the interface.
Configuring EBGP between a PE and a CE
1. Configure the PE:
Step
1. Enter system view.
2. Enable BGP and enter BGP
view.
3. Enter BGP-VPN instance
view.
4. Configure the CE as the
VPN EBGP peer.
Command
ospfv3 process-id area area-id
[ instance instance-id ]
Command
system-view
isis [ process-id ] vpn-instance
vpn-instance-name
network-entity net
ipv6 enable
quit
interface interface-type
interface-number
isis ipv6 enable [ process-id ]
Command
system-view
bgp as-number
ip vpn-instance
vpn-instance-name
peer { group-name |
ipv6-address [ prefix-length ] }
as-number as-number
283
Remarks
By default, OSPFv3 is disabled on
an interface.
Perform this configuration on the
PE.
Remarks
N/A
Perform this configuration on the
PE. On the CE, create a common
IPv6 IS-IS process.
By default, no NET is configured.
By default, IPv6 is disabled.
N/A
N/A
By default, IPv6 IS-IS is disabled on
an interface.
Remarks
N/A
N/A
N/A
By default, no BGP peer is
configured.