Enabling L2Vpn; Configuring An Ac - HP 6127xlg Configuration Manual

To configure VPLS on a PE, perform the following tasks:
Tasks at a glance
(Required.)
(Required.)
(Required.)
Configuring a
•
(Optional.)
•
(Required.) Choose either of the following tasks to configure a PW:
Configuring a static PW
Configuring an LDP PW
(Required.)
(Optional.)
•
Configuring static PW redundancy
•
Configuring LDP PW redundancy
(Required.)
(Optional.)

Enabling L2VPN

Before you enable L2VPN, perform the following tasks:
Configure an LSR ID for the PE with the mpls lsr-id command.
•
Enable MPLS with the mpls enable command on the backbone interface of the PE.
•
To enable L2VPN:
Step
1. Enter system view.
2. Enable L2VPN.

Configuring an AC

CAUTION:
On a PE, if the interface connected to a PW and the interface connected to an AC reside on different IRF
•
member devices, the default VLAN ID configured on the interface connected to the AC must be different
from the inner VLAN ID of the packets to be forwarded from the PW to the AC.
On an interface, Ethernet service instance is mutually exclusive with EVB. For more information about
•
EVB, see
Enabling L2VPN
Configuring an AC
Configuring a VSI
PW:
Configuring a PW class
Binding an AC to a VSI
Configuring UPE dual homing:
Configuring MAC address learning
Enabling packet statistics for an Ethernet service instance
EVB Configuration Guide
Command
system-view
l2vpn enable
.
377
Remarks
N/A
In an H-VPLS using MPLS access, do
not perform this task on the access
NPEs of the UPEs.
N/A
Choose a PW configuration
method depending on the VPLS
implementation.
In an H-VPLS using MPLS access, do
not perform this task on the access
NPEs of the UPEs.
N/A
N/A
N/A
Remarks
N/A
By default, L2VPN is disabled.