HP 6127xlg Configuration Manual page 430

Step
9. Configure a PW, specify the
created PW class for it, and
enter PW view.
10. (Optional.) Configure the
local and remote
discriminators for the BFD
session used to verify PW
connectivity.
11. (Optional.) Configure a
backup PW, specify the PW
class for the backup PW,
and enter backup PW view.
12. (Optional.) Configure the
local and remote
discriminators for the BFD
session used to verify the
connectivity of the backup
PW.
Configuring BFD for a VPLS static PW
Step
1. Enter system view.
2. Enable BFD for MPLS.
3. Create a PW class and enter
PW class view.
4. Use BFD to verify PW
connectivity.
5. Specify the VCCV CC type.
6. Return to system view.
7. Enter VSI view.
8. Configure the VSI to
establish static PWs and
enter VSI static view.
Command
peer ip-address pw-id pw-id
[ in-label label-value out-label
label-value ] pw-class class-name
[ tunnel-policy tunnel-policy-name ]
bfd discriminator local local-id
remote remote-id
backup-peer ip-address pw-id
pw-id [ in-label label-value
out-label label-value ] pw-class
class-name [ tunnel-policy
tunnel-policy-name ]
bfd discriminator local local-id
remote remote-id
Command
system-view
mpls bfd enable
pw-class class-name
vccv bfd [ template
template-name ]
vccv cc router-alert
quit
vsi vsi-name [ hub-spoke ]
pwsignaling static
421
Remarks
By default, no PW is configured.
By default, no local and remote
discriminators are configured.
Make sure the local discriminator
and remote discriminator configured
on the local PE are the same as the
remote discriminator and local
discriminator configured on the
remote PE, respectively.
By default, no backup PW is
configured.
By default, no local and remote
discriminators are configured.
Make sure the local discriminator
and remote discriminator configured
on the local PE are the same as the
remote discriminator and local
discriminator configured on the
remote PE, respectively.
Remarks
N/A
By default, BFD for MPLS is disabled.
By default, no PW class is created.
To use BFD to verify connectivity of a
PW, you must create a PW class for
the PW and configure VCCV
settings in PW class view.
By default, BFD is not used to verify
PW connectivity.
By default, no VCCV CC type is
specified.
N/A
N/A
N/A