Table of Contents
Advertisement
Operation
9.2 Working with the processing unit
Parameters
Path
Port
IdleStr.
Ports>
TCP/RS232
IP Address
Ports>
Archive
Port
Ports>
Archive
Timeout
Ports>
Archive
Parameters
Path
Integrate
Source
Integrate>
Trigger
Edge
Integrate>
(only if Source=
Trigger
TCP/RS-232)
String
Integrate>
(only if Source=
Trigger
TCP/RS-232)
Debounce
Integrate>
Trigger
9-6
Possible Values
Default
Freely selectable
\r\n
character string
xxx.xxx.xxx.xxx
192.168.0.45
(xxx=0 to 255)
1 to 65535
8765
0 to 3600
10
Possible Values
Default
DI/DO
•
DI/DO
DP or PNIO
•
TCP/RS-232
•
Rising
•
Rising
Falling
•
ASCII characters
T
0 to 9999 ms
0 ms
Meaning
String to determine whether the
connection still exists between the
processing unit and the Ethernet RS-232
converter or the PC/PG on which a TCP
server runs. It is transferred cyclically.
Select this so that the recipient can
clearly distinguish it from the generated
results.
The string can be a maximum of 100
bytes.
IP address of the server for diagnostic
information
Corresponding port of this server
0: There is no transfer of cyclic
•
monitoring frames to check the
connection between processing unit
and server.
Otherwise: Time in seconds after
•
which a monitoring frame is sent to
check the connection between
processing unit and server. If the
server does not respond to this
frame within the monitoring time, an
error is output (only when the
processing unit is in RUN) and the
connection is reestablished.
Meaning
Here, you set the port over which the
trigger signal is sent to the processing
unit.
The function indicates whether the
trigger is on a rising or falling edge.
If the string specified here is sent over
the RS-232 port of an RS-232 Ethernet
converter or a TCP server, the
processing unit generates a trigger
signal.
The function indicates the period for
which triggers are ignored due to
debouncing.
Vision Sensor SIMATIC VS120
Operating Instructions, Edition 02/2006, A5E00757507-01
Advertisement
Table of Contents
