Siemens SIMATIC VS120 Operating Instructions Manual page 67

Step 2: Setting the parameters for the IP configuration of the VS120 processing unit in STEP 7
For a description, refer to the section:
in HW Config
Step 3: Integrating your PC in the PROFINET IO network
Notice
• The network attachment must not have an IP address that is already being used in your
• The IP address of the PC must be in the same subnet as the IP address of the VS120
1. Click Start > Settings > Network and Dial-up Connections
2. In the "Network and Dial-up Connections" dialog, select the existing local area connection
3. Select "Properties" in the context menu and select the "Internet Protocol (TCP/IP)" entry.
4. Click the "Properties" button
5. Select the "Use the following IP address" radio button
6. Adapt the "IP address" and "Subnet mask" to your PROFINET IO network
Step 4: Establish the Ethernet connection
1. Establish an Ethernet connection between your PC and a switch in your existing
2. Establish an Ethernet connection between the VS120 processing unit and your existing
Next step
Follow the steps described in the section
Vision Sensor SIMATIC VS120
Operating Instructions, Edition 02/2006, A5E00757507-01
8.4 Establish an Ethernet connection between the processing unit and PG / PC
network
processing unit. If necessary, the port configuration of the PC must be adapted
to the network. This must have the status "Enabled".
PROFINET IO network. Use a network cable of the type "Ethernet RJ-45"
network. Use a network cable of the type "Ethernet RJ-45"
Integrating the PROFINET IO device SIMATIC VS120
Check whether a proxy server is being used
Commissioning
.
8-11