Table of Contents
Advertisement
Process interfacing over an automation system (PLC, PC)
10.3 Control over the "DI/DO" I/O interface
Model selection
To select a model, apply the appropriate bit pattern to the inputs SEL0 to SEL3. You can
select models 1 to 15. If all the inputs of "Select" are set to 0, the last selected model is
retained.
Figure 10-3
Legend:
Δt of the model at, for example, Δt
*)
and Δt
Note
Only 15 models can be selected. If there is a larger number of models, the selection must be
made using model sets.
10-8
Model selection
= depending on model/model set. This process may take a few minutes.
max
= 150 ms (regardless of model/model set)
min
Operating Instructions, Edition 02/2006, A5E00757507-01
Vision Sensor SIMATIC VS120
Advertisement
Table of Contents
