Table of Contents
Advertisement
4.7
Job parameter
4.7
The Job parameter has the options "Find" and "Identify"
Find
If the "Find" option is selected, additional edges of the specimen are not taken into
consideration.
Identify
If the "Identify" option is selected, additional edges of the detected specimen are taken into
consideration and compared with the edges of the reference model.
Example
Metal plate with three holes. If "Find" is set, the quality 100% will be output for a metal plate
with an additional hole. If "Identify" is set, the quality value will be lower because the
additional edges of the fourth hole do not have corresponding edges in the reference image.
Vision Sensor SIMATIC VS120
Operating Instructions, Edition 02/2006, A5E00757507-01
Image processing
4.7 Job parameter
4-13
Advertisement
Table of Contents
