Processing - Siemens SIMATIC VS120 Operating Instructions Manual

Part 5/5: Save
You can save a trained model by opening the Training - Save tab. In the Number and Name
text boxes, enter the number and name (max. 8 characters) of the model you want to save.
Figure 9-17
9.3.5

Processing

The "Processing" panel is divided into two areas: You start processing a model or model set
with "Start" on the left. Statistics on the currently running process are also displayed in a
multiple-page area. This corresponds to the results shown in the Info - Statistics tab.
• The Q limit and warning limit can be increased or decreased using the Q Limit button for
• On the right, you can see the most recently processed image. The results from the last
• A table below the current image shows the result of the most recent evaluation. The
Vision Sensor SIMATIC VS120
Operating Instructions, Edition 02/2006, A5E00757507-01
Training - Save tab
optimizing the processing. The current value is shown beside the buttons and the
modified values can be stored on the controller with "Apply".
evaluation are also graphically displayed in this image. The results to be displayed can be
configured in drop-down lists and check boxes located next to and below the image.
content of the table can be configured with a drop-down list next to the current image.
Operation
9.3 Working with setup support
9-33