3Com AP9152 Hardware Installation Manual page 7

Installing the wall-mounting bracket on the wall
Installing the AP on the wall-mounting bracket
Locking the AP onto the wall-mounting bracket (optional)
Installing the wall-mounting bracket on the wall
Step1 Place the wall-mounting bracket tightly against the wall where the AP is to be
mounted and mark the locations to drill holes for installing the screws. Then use
a drill with a bit of 6 mm (1/4 in.) in diameter to drill holes in the wall. The hole
pattern must be identical with that in the wall-mounting bracket.
Highlight:There are five mounting holes in total in the wall-mounting bracket of the
AP9152. Select the three round holes (with a diameter of 5 mm, or 0.20 in.) for the
installation.
Figure1 Mounting hole pattern of the AP9152 wall-mounting bracket:
Step2 Insert the pointed ends of wall anchors into the drilled holes and tap the flat
ends of wall anchors with a rubber hammer until they are all flush with the wall
surface.
Step3 Align the holes in the wall-mounting bracket with the wall anchors and insert
screws through the mounting holes into the wall anchors, as shown in Figure2.
4