Preparing For Installation; Unpacking And Inspection - 3Com AP9152 Hardware Installation Manual

LED Color
2.4G
Green
(Wireless
link LED)
5G
Green
(Wireless
link LED)
Interfaces
The AP9152 provides a console interface and an Ethernet interface.
Note: The AP9152 provides a reset button and a security slot.
Descriptions of the interfaces on the AP9152:
Interface Standards and
silkscreen
CONSOLE RS/EIA-232
IEEE802.3
ETHERNET IEEE802.3u
IEEE802.3af
Caution: When connecting a cable to an interface, pay attention to the interface
silkscreen to avoid connection mistakes.

2 Preparing for Installation

Unpacking and Inspection

Before unpacking the unit, make sure that the package is intact, without any sign of
damage. When unpacking the unit, avoid excessive force; otherwise, the unit inside the
package may get damaged.
After unpacking the unit, check that all items listed on the packing list are contained. If
any of the items are missing, contact your local dealer immediately.
State
The wireless link is not initialized or the link is
Off
faulty.
Blinking
The wireless link is working normally.
slowly
Blinking
Data is being transmitted or received.
rapidly
The wireless link is not initialized or the link is
Off
faulty.
Blinking
The wireless link is working normally.
slowly
Blinking
Data is being transmitted or received.
rapidly
protocols
The console interface is used for device
configuration and management.
Default: 9600 baud rate, 8 data bits, no parity,
one stop bit.
The default username and password for
console login are admin and password (case
sensitive) respectively
The Ethernet interface can serve as an uplink
interface to access the Internet and as a PoE
interface at the same time.
Description
Description
2