3Com AP9152 Hardware Installation Manual page 12

(1) M3 × 6 screw
(3) Mounting hook
(5) Mounting clip
(7) Screw hole
(9) Key-hole clip
Power Supply by PoE
Power is supplied to the AP9152 through a PoE module or PoE switch. Connect one
end of an Ethernet cable to the Ethernet interface of the AP9152 and the other end to
an Ethernet interface of the PoE device.
Caution: Identify the mark on the device to avoid taking the console interface for the
Ethernet interface, or vice versa.
4 Connecting the AP(FAT AP)
On a Network with a DHCP Server
The DHCP server automatically assigns an IP address to the AP.
To find the address, either get it from the DHCP Server, or enter the following command
at the CLI interface:
<9152> display vlan 1
Figure8 Mount the AP to the T-rail
(2) T-rail
(4) T-rail holder
(6) Wall-mounting bracket
(8) M4 × 8 screw
(10) M4 × 8 screw
9