Connecting Cables (Ac Power Supply) - Zte NetNumen U31 R06 Hardware Installation Manual

NetNumen™ U31 R06 Hardware Installation Guide
6. Lock the alarm box.
– End of Steps –

11.2.2 Connecting Cables (AC Power Supply)

When the alarm box uses an
socket should be near the alarm box.
Note:
The AC adaptor is delivered with a 2-meter-long
power cable. The alarm box must be installed within the reach of the
The AC power cable and network cable should be covered by trunking and secured on the
wall. Cable bends should be smooth.
Caution!
Do not strain the cables because this can result in damage.
This procedure describes how to connect the
the alarm box.
Prerequisite
l
The power cable and a straight-through network cable (RJ-45 connector) are
connected and routed properly.
l
A screwdriver and cable ties are ready.
l Ensure that the
Steps
1. Connect one end of the network cable to the network interface of the alarm box, and
then connect the other end to the port of the hub or to the layer-2 switch that resides
in the same
2. Connect the three-pole plug of the
the other end to the
Figure
SJ-20141121113158-006|2014-12-20 (R1.0)
AC
AC socket is switched off.
LAN with the alarm server.
AC adaptor. For the
11-3.
power supply, an AC adaptor should be used and an
DC power cable and a 2-meter-long
AC power cable and the network cable to
AC power cable to the
AC adapter and the
11-4
AC power cable.
AC socket, and then connect
AC power cable, see
ZTE Proprietary and Confidential
AC
AC