Appendix A Making A Power Cable And A Grounding Cable; Figure A-1 Cutting Out A Cable - Zte NetNumen U31 R06 Hardware Installation Manual

Appendix A
Making a Power Cable and a
Grounding Cable
This appendix describes how to prepare a power cable or a grounding cable that are used
between a cabinet and the power distribution box.
Note:
Different power distribution boxes may provide different cable terminals. The single-hole
O-type terminal is used as an example.
Power cables and grounding cables are prepared in the same way.
preparation is used as an example.
Prerequisite
l
The required length of the power cable is determined.
l
Wire clippers, wire strippers, a crimping tool, a heat gun, and gloves are ready.
Steps
1. Use the wire clippers to cut out a cable that is slightly longer than the required length,
see Figure

Figure A-1 Cutting Out a Cable

2. Put a heat-shrink tube onto the cable, see
SJ-20141121113158-006|2014-12-20 (R1.0)
A-1.
A-1
Figure A-2.
ZTE Proprietary and Confidential
Power cable