Steps
1. Wear the
terminal of the strap into the
2. Take out the board from the anti-static package, verify that the board memory is
properly installed and the extractors are locked in position.
memory properly installed.
Caution!
Do not directly contact the components in the board. Failure to comply can result in
damage to the board.
Do not hold the board by only catching the extractors. Failure to comply can result in
damage to the extractors.
Figure 7-7 Checking the Memory Installation
If the memory bar is not in position, perform the following steps to reinstall it.
a. Move aside the extractors on two sides of the memory bar and remove the memory
bar from the slot, see
SJ-20141121113158-006|2014-12-20 (R1.0)
ESD
wrist strap (or anti-static gloves), and then connect the grounding
ESD
Figure
Chapter 7 Assembly Installation in a Cabinet
jack on the shelf, see
7-8.
7-7
ZTE Proprietary and Confidential
Figure
7-4.
Figure 7-7
shows a