Chapter 3 Unpacking And Checking Equipment - Zte NetNumen U31 R06 Hardware Installation Manual

Chapter 3
Unpacking and Checking
Equipment
This procedure describes how to unpack wooden cases, cartons, and the board package.
For how to count and check equipment, refer to Unpacking Inspection Guide of Core
Network Products.
l
A wooden case is used to pack a cabinet.
l A carton is used to pack boards, terminal equipment, and cables.
Prerequisite
A flathead screwdriver, a claw hammer, diagonal pliers, a paper knife, antistatic gloves (or
an ESD wrist strap) are ready.
Steps
1. Check the total number of equipment in accordance with the Packing List, and then
verify that the outer packing is complete.
2. Remove the outer packing of the wooden case.
a. Move the wooden case with a fork truck to the cabinet installation site in the
equipment room.
b. Open all tongue pieces with a flathead screwdriver, remove the upper cover of the
case, and then remove the sideboards, see
SJ-20141121113158-006|2014-12-20 (R1.0)
Figure
3-1
ZTE Proprietary and Confidential
3-1.