Chapter 6: Installation reference
Console and management connections
The front panel of the switch contains the Status LEDs, Console port, and a USB 2.1 port.
The rear panel of the switch contains the Base Unit switch.
Console port
The console port is the RJ45 port with a blue border outline. You can use the console port to
establish a management terminal connection to the switch. You can use an RJ45 to DB-9 cable, or
a DB-9 to RJ45 adapter to connect the switch console port to your management terminal. The
maximum length of a console cable is 25 feet (8.3 meters).
The following figure and table describe the RJ45 console port pin-out information. You can use the
pin-out information to verify or create a console cable for use with your maintenance terminal.
Figure 7: RJ45 console port pin-out
RJ45 console port pin-out
1
2
3
4
5
January 2017
Signal
RTS (ready to send)
DTR (data terminal ready)
TXD (transmit data)
DCD (carrier detect)
GND (ground)
Installing Avaya Ethernet Routing Switch 3600 Series
Comments on this document? infodev@avaya.com
Requirement
Optional (can be swapped or
linked with pin
Optional
Mandatory
Optional
Mandatory
Table continues...
35