Using Paper From A New Size Standard - Oki Teriostar LP-1030 User Manual

Using Paper from a New Size Standard

Chapter
1
Chapter
2
Chapter
3
Chapter
4
Chapter
5
76 76
LP-1030/LP-1030-MF User's Manual for Basic Printer Operation
This Printer supports the paper of the following size standards.
A series
ARCH series
ANSI series
30×42 series
MAP series
DIN series
User Defined series
The Printer's factory default setting is A series.
Check the size standard currently specified on your Printer in
Standards ( & page
This section describes the procedure to add a new size standard. The following is
described taking ANSI series as an example, and the same procedure is applied
to the other size standards. For user defined series, see
Defined Series ( & page
(1) Set the available size standards
In Available Size Standards ( & page
Note
It is not possible to set all the size standards to Off.
‹
When the Available Size Standards setting is changed, the Printer restarts.
‹
(2) Set the paper size standards
The rolls available in the ANSI series are 34 inches, 22 inches, 17 inches, and 11
inches. Set the roll you will actually use to On in
99). You are recommended to set all unrequired roll widths to Off.
Note
It is not possible to set all the paper size standards in the same size standard
‹
to Off
When the Paper Size Standards setting is changed, the Printer restarts.
‹
98). (The size standard set to On is activated.)
78).
98), set ANSI series to On.
Available Size
Using Paper from a User
Paper Size Standards ( & page