Oki Teriostar LP-1030 User Manual page 130

Setup Items in PDL Settings Menu
T
Chapter
1
n
Chapter
2
Chapter
3
Chapter
4
n
Chapter
5
n
130
LP-1030/LP-1030-MF User's Manual for Basic Printer Operation
Drawing Size Command (only with HP-GL)
The parameter specifies PS, IP, or IW to be applied to the drawing size.
If the drawing size of the data is not specified correctly, set this parameter to Off.
<Parameter by selecting options>
Off
On (PS)
n
On (IP)
On (IW)
Note that the function of the IP and IW values differs depending on your CAD
z
application, which may cause print defects. To prevent it, before selecting On (IP) or
On (IW), be sure to check that IP or IW value is obviously specified as the drawing size.
When the data includes the PS value at On (IP) or On (IW), the PS value is prioritized.
z
Drawing (only with D-SCAN)
The parameter specifies drawing print.
<Parameter by selecting options>
NOP
n
EOF
Identify by Paper Number (only with D-SCAN)
With the parameter, the paper number is identified as paper position or paper type.
<Parameter by selecting options>
Off
Paper Position
n
Paper Type
: Default value
n
Disables the drawing size command.
Specifies the PS value as the drawing size.
Specifies the IP value as the drawing size.
Specifies the IW value as the drawing size.
: Default value
n
Does not perform drawing print.
Performs drawing print.
: Default value
n
Disables the paper number in the information block.
Identifies the paper number as the paper position.
Identifies the paper number as the paper type.