Oki Teriostar LP-1030 User Manual page 48

Replacing the Roll Paper
T
Chapter
1
3
Chapter
2
Chapter
3
4
Chapter
4
5
Chapter
5
6
48
LP-1030/LP-1030-MF User's Manual for Basic Printer Operation
Flange guide Paper flange
Paper feed knob
Cutter
ロール紙の交換 1 2 3 4
Replacing Roll Paper
用紙カッ ト位置
Paper Cut Position
Set the roll paper into the Printer.
Hold the roll paper so that the paper end hangs
down from the bottom toward the Printer. Slowly
insert the paper flange while aligning it with the
groove on the flange guide.
Note
Be careful not to drop the roll paper.
‹
Insert the end of the roll paper inside
the paper inlet.
By manually rotating the paper flange, feed the
roll paper.
By rotating the paper feed knob, feed
the roll paper so that a the top of the
roll paper protrude from the printer by
approximately 60 cm (23.63 inch).
60 cm
(23.63 inch)
While holding the end of the roll paper,
cut the paper with the cutter.
The Paper Cut Position label is affixed to the
left end of the groove for the cutter edge.
5 6 7
Insert the edge of the cutter in the groove above
the label and cut the paper by moving the cutter
along the groove.