Drawing Parameters - Oki Teriostar LP-1030 User Manual

Setup Items in PDL Settings Menu
T
Chapter
1
‹ Drawing Parameters
Chapter
2
n
Chapter
3
n
Chapter
4
Chapter
5
n
116
LP-1030/LP-1030-MF User's Manual for Basic Printer Operation
Drawing parameters specify the print conditions.
Parameter Mode (only with D-SCAN)
When a parameter is selected with both data and touchpanel, the parameter mode
specifies the parameter priority.
<Parameter by selecting options>
Data Setting
n
Panel Setting
Offset Mode
The offset mode selects Same Drawing Size with Top and Bottom Blank, Offset
with Paper Size Change, or Offset without Paper Size Change as the offset
function.
<Parameter by selecting options>
Same Drawing Size with
n
Top and Bottom Blank
Offset with
Paper Size Change
Offset without
Paper Size Change
Same Drawing Size with Top and Bottom Blank
The parameter specifies the blank space size to add around a printed image at the
same size as the original. Note that the parameter is valid only when the offset
mode is set to Same Drawing Size with Top and Bottom Blank.
<Parameter by entering numbers>
0 to 100
: Default value
n
The parameter specified with data is validated.
The parameter specified with touchpanel is validated.
: Default value
n
The parameter selects the same drawing size with the top
and bottom blank as the offset function. The Same Drawing
Size with Top and Bottom Blank setting is enabled.
The parameter selects the X offset and Y offset as the offset
function. The X Offset and Y Offset settings are enabled. The
page size is increased or decreased by the offset amount.
The parameter selects the X offset and Y offset as the offset
function. The X Offset and Y Offset settings are enabled. Note
that the offset function does not affect the printed image
size. As a result, the printed image may be clipped. When
the printed image size is not specified, the Printer prints the
image in the Offset with Paper Size Change mode.
Default value = 0, Unit in mm