List Of Hp Rtl Printing Commands - Oki Teriostar LP-1030 User Manual

‹ List of HP RTL Printing Commands
The meaning of the symbols in the table is as follows.
Yes: Indicates commands supported by the Printer.
Partially: Indicates commands whose functions are partially supported by the Printer.
No: Indicates commands not supported by the Printer.
If the Printer receives any non-supported commands, it ignores them. If a command that
is not in the table is received, it results in a command error.
Command
Name
Enter HP-GL/2 Mode
Enter PCL Mode
Reset
Universal Exit Language/Start of
PJL
Apple Talk Configuration
Configure Image Data
Set Red Parameter
Set Green Parameter
Set Blue Parameter
Assign Color Index
Push/Pup palette
Source Raster Width
Source Raster Height
Move CAP Horizontal (Decipoints)
Move CAP Horizontal
Move CAP Vertical
Y Offset
Destination Raster Width
Destination Raster Height
Raster Line Path
Negative Motion
Set Graphics Resolution
Start Raster Graphics
End Raster Graphics
Transfer Raster Data by Plane
Transfer Raster Data by Row/Block
Set Compression Method
Foreground Color
Render Algorithm
Code
ESC % # B Transitions to HP-GL/2 mode.
ESC % # A Transitions to PCL mode.
ESC E Resets.
ESC % # X Starts PJL.
ESC & b # W [bin data] Communicates with the Apple Talk driver.
ESC * v # W [data] Configures the image data.
ESC * v # a|A Sets the red parameter.
ESC * v # b|B Sets the green parameter.
ESC * v # c|C Sets the blue parameter.
ESC * v # i|I Assigns the color index number.
ESC * p # P Pushes or pops the palette.
ESC * r # s|S Sets the source raster width.
ESC * r # t|T Sets the source raster height.
Performs CAP horizontal movement
ESC & a # h|H
(decipoints).
ESC * p # x|X Performs CAP horizontal movement.
ESC * p # y|Y Performs CAP vertical movement.
ESC * b # y|Y Sets the Y direction offset.
ESC * t # h|H Sets the destination raster width.
ESC * t # v|V Sets the destination raster height.
ESC * b # l|L Sets the raster line path.
ESC & a # n|N Specifies a negative movement.
ESC * t # r|R Sets the graphics resolution.
ESC * r # a|A Indicates the start of raster graphics.
ESC * r C Indicates the end of raster graphics.
ESC * b # V [data] Transmits the raster data in plane units.
ESC * b # W [data] Transmits the raster data in row/block units.
ESC * b # m|M Sets the compression method.
Sets the RGB value of the specified index
ESC * v # s|S
number as the lower limit for raster printing.
Specifies the algorithm for expressing neutral
ESC * t # j|J
color data.
LP-1030/LP-1030-MF User's Manual for Basic Printer Operation
Command Lists
T
Function Supported
Partially (
Partially (
Partially (
Partially (
Partially (
Partially (
Partially (
Chapter
1
Chapter
2
(1/2)
Chapter
3
1
)
2
)
3
)
No
Chapter
No
4
4
)
Yes
Yes
Yes
5
)
6
)
Chapter
5
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
7
)
235