Snmp - Planet GRT-101 User Manual

G.SHDSL Bridge/Router
GRT-101/401/402 User's Manual
Supervisor ID: Type the new ID
Supervisor Password: Type the existing password ("root" is the default password when
shipped)
Password Confirm: Retype your new password for confirmation.
Telnet Port: For Telnet, you may change the default service port by typing the new port
number. If you change the default port number then you will have to let user who wish to use
the service know the new port number. The default value is 23.
On trust host list, configured 0.0.0.0 will allow all hosts on Internet or LAN to access the router.
Leaving blank of trust host list will cause blocking all PC from WAN to access the router. On
the other hand, only PC in LAN can access the router.
If you type the exact IP address in the field, only the host on this listing can access to the
router.
Click Finish to finish the setting.
The browser will prompt the all configured parameters and check it before writing into NVRAM.
Press Restart to restart the gateway working with the new parameters and press Continue to
set up other parameters.

6.2 SNMP

Simple Network Management Protocol (SNMP) provides for the exchange of messages
between a network management client and a network management agent for remote
management of network nodes. These messages contain requests to get and set variables
that exist in network nodes in order to obtain statistics, set configuration parameters, and
monitor network events. SNMP communications can occur over the LAN or WAN connection.
The router can generate SNMP traps to indicate alarm conditions, and it relies on SNMP
community strings to implement SNMP security. This router support MIB I and MIB II.
Click SNMP to configure the parameters.
- - 78