Enable - Planet GRT-101 User Manual

>> enable Modify command privilege
status Show running system status
show View system configuration
ping Packet internet groper command
exit Quit system
------------------------------------------------------------------------
If you need setup and manage the router, you must set enable command before.

10.7 Enable

To set up the router, move the cursor " >>" to enable and press enter key. While the screen
appears, type the supervisor password. The default supervisor password is root. The
password will be prompted as " * " symbol for system security.
----------------------------------------------------------------------
Command: enable <CR>
Message: Please input the following information.
Supervisor password: ****
----------------------------------------------------------------------
In this sub menu, you can set up management features and upgrade software, backup the
system configuration and restore the system configuration via utility tools.
For any changes of configuration, you have to write the new configuration to EPROM and
reboot the router to work with new setting.
The screen will prompt as follows:
>> enable
setup
status
show
write
reboot
ping
admin
utility
exit
The description of the commands is:
Command
Modify command privilege. When you login via serial console or Telnet,
enable
the router defaults to a program execution (read-only) privileges to you.
Modify command privilege
Configure system
Show running system status
View system configuration
Update flash configuration
Reset and boot system
Packet internet groper command
Setup management features
TFTP upgrade utility
Quit system
GRT-101/401/402 User's Manual
Description
105 - -
G.SHDSL Bridge/Router