Planet GRT-101 User Manual page 144

>> active
add
delete
modify
list
----------------------------------------------------------------------
You can enable the IP QoS function via active command.
The add parameters of IP QoS can be configured via add command
To delete the policy is configured by delete command.
To modify the policy is configured by modify command.
You can view the IP QoS configuration via list command.
When use the add command, it will show the following:
>> Protocol
local_ip
remote_ip
Port
description
Enable
Precedence
Protocol identifier: One can differentiate IP from other network level protocols using link level
information - TCP (Transmission Control Protocol) and UDP (User Datagram Protocol).
Source port number: The only way to identify applications run over TCP or UDP is to look for
port numbers and compare them to the list of well-known port numbers. While in most cases
the mapping is correct, there are cases when some services or clients use a port reserved for
another application.
Destination port number: The destination port identifies traffic originating from the client to
the server.
Source host address: It can identify the end system sending data and based on that
classify traffic
Destination host address: It can identify the end system receiving data.
Command
Protocol Set up the port protocol type (ANY, TCP or UDP)
Local_ip Configure the local IP address
Remote_ip Configure the remote IP address
Port Configure the local port and remote port range
Description Define the description of policy
Enable Enable the policy
Precedence Define the priority of the policy
Trigger IP QoS function
Add IP QoS policy
Delete IP QoS policy
Modify IP QoS policy
Show IP QoS policy table
Configure protocol
Configure local IP parameter
Configure remote IP parameter
Configure port parameter
Policy description
Enable the policy
Configure precedence parameter
GRT-101/401/402 User's Manual
Description
144 - -
G.SHDSL Bridge/Router