Route - Planet GRT-101 User Manual

Once you enable the STP feature, you can see the STP status follow IEEE 802.1d standard to work.
The working steps are Blocking, Listening, Learning and forwarding.

10.16.6 Route

You can set up the routing parameters in route command. If the product is configured as a
bridge, you do not want to set up the route parameters. Move the cursor " >> " to route and
press enter.
>> static
rip
10.16.6.1 Static
If the Router is connected to more than one network, it may be necessary to set up a static
route between them. A static route is a pre-determined pathway that network information must
travel to reach a specific host or network.
With Dynamic Routing, you can enable the Router to automatically adjust to physical changes
in the network's layout. The Router, using the RIP protocol, determines the network packets'
route based on the fewest number of hops between the source and the destination. The RIP
protocol regularly broadcasts routing information to other routers on the network.
You can set up 20 sets of static route in static command. After entering static menu, the
screen will show as follows:
>> add
delete
List
You can add 20 sets of static route entry by using add command. Type the IP information of
the static route including IP address, subnet mask and gateway.
Static Route Table:
IP Address
1
2
3
4
5
6
7
8
9
10
Configure static routing table
Configure RIP protocol
Add static route entry
Delete static route entry
Show static routing table
Subnet Mask Gateway
GRT-101/401/402 User's Manual
132 - -
G.SHDSL Bridge/Router