Planet GRT-101 User Manual page 133

11
12
13
14
15
16
17
18
19
20
You can delete the static route information via delete command.
You can review the static route entry by using list command.
10.16.6.2 Rip
To configure Routing Information Protocol (RIP), you can use rip command to set up the
parameters. Move the cursor ">>" to rip and press enter.
>> generic
lan
wan
list
Generic RIP Parameters
Generic command can set up RIP mode and auto summary mode.
Generic RIP Parameter:
Rip Mode □Disable
Auto Summary □Disable
Interface RIP Parameters
[ LAN ]
If there are other routers in your LAN, you can configure LAN interface RIP parameters via lan
command.
-----------------------------------------------------------------------------
Command: setup route rip lan <1~1> <more...>
Message: Please input the following information.
Active interface number <1~1>:
-----------------------------------------------------------------------------
The screen will prompt as follows:
-----------------------------------------------------------------------------
>> attrib
version
authe
Configure operation and auto summery mode
Configure LAN interface RIP parameters
Configure WAN interface RIP parameters
Show RIP configuration
□Enable
□Enable
Operation, authentication and Poison reverse mode
RIP protocol version
Authentication code
GRT-101/401/402 User's Manual
133 - -
G.SHDSL Bridge/Router