Status - Planet GRT-101 User Manual

To change the configuration and write changes to nonvolatile RAM
(NVRAM), you must work in enable mode.
setup To configure the router, you have to use the setup command.

status

View the status of router.
show Show the system and configuration of router.
Update flash configuration. After you have completed all necessary
setting, make sure to write the new configuration to NVRAM by "write"
write
command and reboot the system, or all of your changes will not take
effect.
Reset and boot system. After you have completed all necessary setting,
reboot make sure to write the new configuration to NVRAM and reboot the
system, otherwise, all of your changes will not take effect.
ping Internet ping command.
admin You can setup management features in this command.
utility Upgrade software and backup and restore configuration.
exit Quit system.
10.8 Status
You can view running system status of SHDSL.bis, WAN, route, interface, fireware, ip_qos
and stp via status command.
Move cursor " >> " to status and press enter.
>> shdsl.bis
lan
wan
route
interface
firewall
ip_qos
stp
clear
Command
The SHDSL.bis status includes line rate, SNR margin, TX power, attenuation, and
CRC error of the product, and SNR margin, attenuation and CRC error of remote
shdsl.bis
side. The router can access remote side's information via EOC (embedded
operation channel).
LAN status shows all their parameters including IP address ,Net mask, Mac
lan
address and protocol information
Show SHDSL.bis status
Show lan interface status
Show WAN interface status
Show routing table
Show interface statistics status
Show firewall status
Show IP QoS statistics
Show STP status
Reset statistics
GRT-101/401/402 User's Manual
Description
106 - -
G.SHDSL Bridge/Router