Bridge - Planet GRT-101 User Manual

Most of the ISPs use dynamic IP for PPP connection but some of the ISPs use static IP. You
can configure the IP type: Dynamic, Fixed and Unnumbered. The setting is via ip_type
command.
The ip unnumbered configuration command allows you to enable IP processing on a serial
interface without assigning it an explicit IP address. The ip unnumbered interface can "borrow"
the IP address of another interface already configured on this router, which conserves network
and address space.
10.16.3.8 List
You can review the WAN interface configuration via list command.

10.16.4 Bridge

You can set up the bridge parameters in bridge command. If the product is configured as a
router, you do not want to set up the bridge parameters. Move the cursor " >> " to
press enter.
>> gateway
static
10.16.4.1 Gateway
You can set up default gateway IP via gateway command.
10.16.4.2 Static Bridging Table
You can set up 20 sets of static bridge in static command. After entering static menu, the
screen will prompt as below:
>> Deby_PCs
add
delete
modify
list
You can deny PCs to access Internet for security purpose use deny_PCs command
After enter add menu, the screen will prompt as follows:
>> mac
lan_port
wan1_port
wan2_port
wan3_port
wan4_port
wan5_port
wan6_port
wan7_port
wan8_port
Deny PCs to access interface:
Deny PCs to access Interface
Static MAC Address:
Default gateway
Static bridging table
Deny PCs to access Internet
Add static MAC entry
Delete static MAC entry
Modify static MAC entry
Show static bridging table
Configure MAC address
Configure LAN interface bridging type
Configure WAN1 interface bridging type
Configure WAN2 interface bridging type
Configure WAN3 interface bridging type
Configure WAN4 interface bridging type
Configure WAN5 interface bridging type
Configure WAN6 interface bridging type
Configure WAN7 interface bridging type
Configure WAN8 interface bridging type
□Disable
GRT-101/401/402 User's Manual
□Enable
128 - -
G.SHDSL Bridge/Router
bridge
and