Planet GRT-101 User Manual page 131

----------------------------------------------------------------------
Command: setup vlan link_mode <1~12> <Access|Trunk>
Message: Please input the following information.
Port index <1~12>: 1
Port link type (Tab select) <Trunk>: Access
----------------------------------------------------------------------
10.16.5.2 Port Base VLAN
With port-based VLAN, the port is assigned to a specific VLAN independent of the user or
system attached to the port. This means all users attached to the port should be members in
the same VLAN. The port based setting performs the VLAN assignment. The port
configuration is static and cannot be automatically changed to another VLAN without manual
reconfiguration.
For Port-based VLAN, user must set up the table using 802.11Q methods. But don't care the
value of VID , PVID or link type.
Port-based VLAN:
No. LAN1 WAN1
1
2
3
4
5
6
7
8
To view the VLAN table, move the cursor to list and press enter.
10.16.5.3 STP
Spanning-Tree Protocol (STP) is a link management protocol that provides path redundancy
while preventing undesirable loops in the network. For an Ethernet network to function properly,
only one active path can exist between two stations
The default is disable.
>> active
STP:
STP Function □Disable
WAN2 WAN3 WAN4
Trigger Bridge STP function
□Enable
GRT-101/401/402 User's Manual
WAN5 WAN6
131 - -
G.SHDSL Bridge/Router
WAN7 WAN8