Table of Contents
Advertisement
The Parameter Edit Page
When the Global Mode User Type parameter is set to Advanced, press the Edit button with
a Parameter selected to view the Parameter Edit page. The Parameter Edit Page allows you to
view the Parameter's Destination (MIDI CC that it sends to VAST parameters), as well as the
currently assigned Control, Text name, and Value. Press the Edit button again to enter the
Parameter Text page, where you can change the name displayed for the Parameter. You can
also press the Delete soft button to delete the current Parameter. Press Exit or the Back soft
button to return to the Parameters page
The Program FX (FX) Page
Press the FX soft button to call up the Program FX (FX) page. This is the page that you will
use to apply effects to a program, and to configure the routing of the various pre- and post-
FX audio signals. Effects chosen on this page affect every layer of the current program. The
section
specific effects. The FX page looks like this:
On the Forte SE, a program can have up to 11 insert effects and 2 aux effects using up to
16 DSP "units." An insert is essentially just an effect that you apply to a program or layer,
while aux effects receive signal from all active programs' aux sends. Note the 0/0 Units in the
middle of the top line of the page. This figure indicates how many of the total units are being
used by the highlighted insert; the left-hand number is the size of the insert, and the right-
hand number is the total number of units being used by the program.
The Layer FX (LYR_FX) Page on page 7-15
Parameter
Insert
Aux 1, Aux 2
Output
Aux Send (dB)
Aux Send (%)
Auxiliary Send
Parameters
Aux Pre/Post Insert
Type
Aux Modulation
The Program FX (FX) Page
contains information on using layer-
Range of Values
Chain List
Chain List
Main, Sec.
off, -95 to 24 decibels
0 to 100%
Post, Pre
dB, %
Control Source List
Program Edit Mode
Default
0 None
0 None
Main
0
0
Post
dB
On
7-13
Advertisement
Table of Contents
