Table of Contents
Advertisement
The Effects Chain Editor
The MOD Pages
NOTE: In some configurations, not all 16 units are available for use with multi-unit
effects because of the way the DSP is allocated internally.
Like all other representations of signal paths in the Forte SE display, the program signal
moves from left to right through the Chain. Use the cursor buttons to select an effect-box
or empty spot in the Chain. The effect loaded into the selected effect-box can be changed
by numeric entry, with the Alpha Wheel, or with the +/– buttons; and can be changed with
either the effect-box or the Effect field at the bottom of the page highlighted. The +/- double
button press will jump to the next effect "category."
Pressing the Insert soft button adds a new effect-box to the Chain in the currently selected
block-slot, and pushes the currently selected effect-box down the Chain to the right. (If you
have run out of DSP units, you will not be able to create additional effects boxes.) Pressing
the Remove soft button takes the currently selected effect out of the Chain.
Editing Effect-boxes
To edit the parameters of an effect, select its effect-box on the MAIN page and press the Edit
button. For each effect, there are one or more pages of parameters that are specific to that
effect. See
Any parameter controlled by an effect Mod will display a value of FxMod and cannot be
edited. To return to the MAIN page of the chain editor, press the Exit button.
The MOD Pages
There are six pages for configuring effects mods: MOD1 - MOD6. All pages are essentially
identical in appearance and function. See below for an example MOD page:
Box
The Box parameter specifies which effect-box in the Chain to which the Mod will be applied.
Param
The Param parameter selects which parameter of the specified box's effect will be modulated.
8-2
Effects Parameters on page 8-5
for details on parameters for each type of effect.
Advertisement
Table of Contents
