Table of Contents
Advertisement
Program Edit Mode
KB3 Editor: The KEYCLICK Page
KeyClick
This is where you turn Key Click on or off. With KeyClick set to Off, you may still hear a
click depending on your Note Attack and Note Release settings (see below).
Volume
This parameter sets the level of the keyclick; the noise decays from the level you set here.
This level is scaled by the drawbar levels, as well as the expression pedal level. Keyclick
volume can also be scaled by MIDI CC 89; value 0 = -96 dB, value 127 = the level set for the
Volume parameter. Values between 0 and 127 scale between -96 dB and the level set for the
Volume parameter. When using CC 89, the value displayed for the Volume parameter will
not change.
Decay
Sets the basic decay time of the noise envelope. Smaller values produce a shorter burst.
VelTrk
Controls the degree to which key velocity affects the key click volume. A value of zero means
that the key velocity has no effect on the key click volume (which is like a real tone wheel
organ). Other values add volume as the velocity increases.
Pitch
Sets the basic pitch of the key click noise, relative to the highest tonewheel's pitch. The pitch
is controlled by a steep lowpass filter applied to white noise. The filter's cut off frequency
is controlled relative to key number, higher keys move the cutoff frequency up, lower keys
move the cutoff frequency down.
Random
Controls the degree to which a random amount of amplitude variation is added to the key
click.
7-90
Parameter
Retrig Thresh
Note Attack
Note Release
Range of Values
-96.0 to 0.0 dB, in 0.5-dB increments
Normal, Hard, PercHard
Normal, Hard
Advertisement
Table of Contents
