Table of Contents
Advertisement
A setting of None means no message is sent when exiting the Multi.
Controlling Program Parameter Assignments from Multi
Mode
Commonly you will want to assign a physical controller in a Multi to control the same
Program parameter that it controlled in Program Mode. In the Destination parameter list,
destinations that are assigned to parameters for the Program of the current Zone will show
the Program Parameter name in place of the standard Controller Destination name. Select
one of these destinations to control an assigned Program parameter.
You can also use the Enter button's secondary "Assign" function to quickly assign a Multi
mode controller to a program mode assignment. First make sure you have the correct
Zone selected for the program you wish to control. Next, go to the Multi CCs or Multi
Switches page and select the desired control. Lastly, select the Dest parameter for the
desired controller, hold the Enter button and move the desired controller. This will set the
controller's destination to the same assignment it had in Program mode. You can also move a
different controller if you want to set a different program mode assignment.
The Controller Destination List
The table below contains the available values for the MIDI CC (continuous controller)
destinations. The Forte SE's physical controllers can send MIDI values to these destinations
in order to control the parameters of Forte SE Programs, Multis, Forte SE system parameters,
or external MIDI equipment.
Controller
Number
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14-21
Controller
Destination
By default, when you enter 0 or Clear for the Destination parameter, the destination
OFF/Bank
will be assigned to OFF. To select Bank as the destination, use the Value buttons.
MWheel
Default destination for the Modulation Wheel
Breath
Default assignment for breath controller in compatible synths
MIDI 03
MIDI Controller 3
Foot
Default assignment for continuous foot controller in compatible synths
Monophonic Forte SE Programs respond to this Controller if portamento is turned
PortTim
on.
Data
MIDI Controller 6
Volume
MIDI Volume
Balance
MIDI Balance
MIDI 09
MIDI Controller 9
Pan
MIDI Pan
Default assignment for CC Pedal. In most Programs it acts as a volume control. It
Express
scales between 0 and the current value of Volume.
MIDI 12
Default assignment for Slider A
MIDI 13
Default assignment for Slider B
MIDI 14-21
MIDI Controllers 14-21
CCTLS (CCs/Continuous Controllers) Page
Description
Multi Edit Mode
11-17
Advertisement
Table of Contents
