Table of Contents
Advertisement
Multi Mode
Other parameters that determine the behavior of the Multi are described below. Use the
navigation buttons to access each of the Split/Layer parameters.
Split/Layer parameters
Zn and Stat (Zone and Status)
Selecting Split or Layer makes a new Zone active. You can continue to add Zones to the
Multi by activating additional Zones with the Stat parameter or the front panel Zone
buttons. The Forte SE will display a message if you have already reached the maximum
number of active Zones (see
About Zones on page 10-6
for more information on Zones).
Program (Split/Layer Program)
The default Program will appear in the next available Zone. Choose a different Program
using the Category and Program/Multi buttons, the Alpha Wheel, or the Previous/Next
buttons.
Low/Hi (Keyboard range)
The Low and Hi parameters set the keyboard boundaries for each Zone.
The low and high keys for each Zone can be selected using Assign
(holding down the
Enter button and then striking the desired key on the keyboard). Keys can also be selected by
using the Alpha Wheel or the Previous-/Next+ buttons.
Vol (Zone Volume)
The VOL parameter determines the volumes of each Zone. By default, VOL is set to 127,
which results in each Zone having the same volume. To change volumes use the Alpha Wheel
or Previous/Next buttons. A Zone volume can be set to any number between 0 and 127.
Pan (Zone Pan)
To change the panning of a Zone (left/right stereo placement), use the navigation buttons to
select the Pan parameter for one of the Zones. To set a Pan value, use the Alpha Wheel, the
Previous-/Next+ buttons, or use the keypad function of the Category buttons to type a pan
value (0-127) followed by the Enter button. A value of 0 is full left, 64 is center, and 127 is
full right. Other values will move the stereo placement in between these positions. A value of
"None" will use the last pan value used by the Zone's MIDI channel. A value of "None" can
be entered by scrolling below 0, or by using the keypad function of the Category buttons to
type negative 1 by pressing the small +/- button and then the 1 button, followed by the Enter
button.
10-11
Advertisement
Table of Contents
