Table of Contents
Advertisement
None can be entered with the alphanumeric function of the Category buttons as -1.
If Sound Select is set to None, then when you load the current Multi, no value will be
transmitted. If you specify an Entry State, then a MIDI controller message with this value
will be sent when you load the current Multi.
Exit State
The Exit State parameter determines the state of the Foot Switch or button that is sent as a
MIDI message when the current Multi is exited. You can set this parameter to None, On, or
Off. This parameter is common to all Zones.
None is entered with the alphanumeric function of the Sound Select buttons as -1.
If Exit State is set to None, then when you leave the current Multi by selecting another Multi
or Program, the Foot Switch or button will remain at whatever value corresponds to its
current position. If you specify an Exit State, then a MIDI controller message with this value
will be sent when you select a different Multi or Program.
COMMON Page
The COMMON page contains parameters that affect every zone in the current Multi. Press
the COMMON soft button to enter the COMMON page.
Tempo
When Clock Source (see
SE's system tempo for this Multi. The Tempo parameter values are in units of BPM (beats
per minute). This controls the tempo the Arpeggiators as well as of any tempo based effects.
Parameter
Tempo
Clock Source
Aux FX Chan
KB3 Channel
page
12-4) is set to Internal, the Tempo parameter sets the Forte
Range Of Values
20 to 400 BPM
Internal, External
1 to 16
1 to 16
Multi Edit Mode
COMMON Page
Default Value
120
Internal
1
1
11-27
Advertisement
Table of Contents
