Table of Contents
Advertisement
LOAD
The LOAD button calls up the LOAD page where you can load compatible files from a
storage device.
Before you press the LOAD selection button in StorageMode, make sure you have plugged
the USB device containing your User Programs and/or Multis into the back of the Forte SE.
If your User Programs/Multis are located on your computer or Tablet, then use the cable that
plugs into the computer/Tablet USB port on the rear panel of the Forte SE.
If your User Programs/Multis are located on a USB flash drive, plug them into the Device
USB port on the rear panel of the Forte SE.
Press the LOAD button when you have the hardware containing your User Programs/Multis
plugged into the USB port.
If no USB connection is detected by Forte SE, you will see the error message "Error: No
valid device inserted.".
Use the navigation buttons, Previous-/Next+ buttons or the Alpha Wheel to browse the files
in the currently selected storage device.
After selecting a file to load, press the FILL or OVWRTE soft button to continue
OPEN
PARENT
FILL
OVERWRITE
(OVWRTE)
During the load process the screen will show information about the objects that are being
loaded. At the end, the screen will display a message indicating if the load process was
successful, or if there were errors.
Pressing the Open soft button will open the highlighted folder.
Selecting Parent will close an existing open folder.
Selecting FILL means you would like to keep the existing User objects.
Forte SE will now load the User objects into the first empty ID slot it
finds, and then subsequent empty slots
Selecting OVWRTE first deletes all the existing User objects, and then
loads the new User objects into the first user location at ID number
1024 onwards.
Global Mode
STORE
.
12-23
Advertisement
Table of Contents
